To select a different test that is in the project, To add a test to a project, To include a fiber test in the % tested value – Fluke Networks CertiFiber Pro Users Manual User Manual
Page 358
Versiv Cabling Certification Product Family
Technical Reference Handbook
336
To Select a Different Test that is in the Project
1
On the home screen, tap the test setup panel.
2
On the CHANGE TEST screen tap the test you want to do. See
Figure 127 on page 324.
3
Tap USE SELECTED.
To Add a Test to a Project
1
On the home screen, tap the test setup panel or the PROJECT
panel.
2
Tap NEW TEST.
3
On the TEST TYPE screen, tap a test.
4
On the TEST SETUP screen, change the test settings as
necessary, then tap SAVE.
To Include a Fiber Test in the % Tested Value
If you add an OptiFiber Pro OTDR, CertiFiber Pro loss length,
FiberInspector, or FaultMap test to a project, but do not select the
test on the CABLE ID SETUP, EDIT CABLE IDs, or IMPORTED IDs
screen, the results you save for the test do not affect the %
Tested value.To include a test in the % Tested value
1
On the home screen, tap the PROJECT panel, then on the
PROJECT screen, tap a fiber ID set that has a First and Last ID.
2
On the EDIT CABLE IDs screen, or the IMPORTED IDs screen
(for ID sets downloaded from LinkWare), select the test under
Select Fiber Tests.
3
Tap SAVE, then tap DONE, or for IMPORTED IDs, tap DONE
then tap DONE again.