Fluke Networks CertiFiber Pro Users Manual - Manual (Page 35)

Chapter 1: Get Acquainted
AC Adapter and Battery
13
LOW BATTERY LED comes on when the battery is low. The LEDs
also have these functions:
 Battery gauge (see Figure 3 on page 15)
 Volume indicator for the TALK function
 Progress indicator for software updates
 Bay for modules, such as the DSX-5000 CableAnalyzer, CertiFiber
Pro, or OptiFiber Pro modules.
  : Starts a test.
  : Power key
  : Press  to use the headset to speak to the person at
the other end of the link. Press again to adjust the volume. To
turn off the talk function, hold down .
 Connector for the AC adapter. The LED is red when the battery
charges, and green when the battery is fully charged. The LED is
yellow if the battery will not charge. See “Charge the Battery”
on page 13.
 Micro-AB USB port: This USB port lets you connect the tester to a
PC so you can install software updates in the tester.
 Headset jack
AC Adapter and Battery
You can use the ac adapter (model VERSIV-ACUN) or the lithium
ion battery (model VERSIV-BATTERY) to supply power to the
tester.
To remove the battery, see “Remove the Battery” on page 364.
Charge the Battery
Before you use the battery for the first time, charge the battery
for about 2 hours with the tester turned off.