Fluke Networks CertiFiber Pro Users Manual - Manual (Page 74)

Versiv Cabling Certification Product Family
Technical Reference Handbook
52
Step 8: Save the Results from End 1
8-1 Tap SAVE (if the result was PASS) or FIX LATER (if the result
was FAIL).
8-2 On the SAVE RESULT screen, tap the Cable ID box, use the
keyboard to enter an ID for the results, then tap DONE.
8-3 Tap SAVE.
Step 9: Do the OTDR Test from End 2
9-1 On the home screen, tap the Next ID panel.
9-2 On the CHANGE ID screen, tap the End 1/End 2 panel control
to make End 2 show.
9-3 Tap DONE.
9-4 Connect the launch and tail cords to opposite ends of the
cabling.
9-5 Tap TEST or press .
Step 10: Save the Results from End 2
10-1 Tap SAVE (if the result was PASS) or FIX LATER (if the result
was FAIL).
10-2 On the SAVE RESULT screen, tap the Cable ID box, use the
keyboard to enter the same ID for the results, then tap DONE.
10-3 Tap SAVE.
Step 11: Look at the Saved Results
11-1 On the home screen, tap the RESULTS icon.
11-2 On the RESULTS screen, tap the ID for the results you saved,
then tap OTDR End 1 or OTDR End 2 to see the results.
For more information on how to use the OTDR, see Chapter 9.