Fluke Networks CertiFiber Pro Users Manual - Manual (Page 344)

Versiv Cabling Certification Product Family
Technical Reference Handbook
322
 To edit the ID, tap the ID, use the keyboard to edit the ID,
then tap DONE. If the ID is not in the current set, the tester
will make a new ID set that uses the ID as the first ID.
 To select a different ID from the set of untested IDs, tap
the ID in the set (
 ).
 End 1:, End 2: When you select a fiber ID set for tests with an
OptiFiber Pro OTDR module or for tests on single fibers with a
CertiFiber Pro OLTS module, this panel shows the name for the
ends of the fiber. The tester uses the names when you save
results for each end of the fiber. To edit the name for the end
shown, tap the panel. To change the end that is shown, tap the
End 1/End 2 control (item
 ).
 IDs Untested: The number of IDs that do not have results. For
fiber IDs, the list shows the IDs that do not have results for the
test shown (Auto OTDR in this example) and the End selected
(item
 ).
 This list shows IDs that do not have results. For fiber IDs, the list
shows the IDs that do not have results for the test shown and the
End selected. On the home screen, the tester shows 100%
Tested when this list shows no IDs for all test types specified in
the project.
When you use a Next ID set, which does not have a Last ID, the
tester does not know how many IDs are necessary for the ID set.
For Next ID sets, this list shows only the next ID.
 Tap CHANGE CABLE IDs to select a different ID set to use or to
edit an ID set.
 Tap DONE to save your changes and go back to the previous
screen.
 Tap this bar or move your finger up or down the bar to scroll to a
different place in the list.
 End 1/End 2 control: When you select a fiber ID set for tests with
an OptiFiber Pro OTDR module or for tests on single fibers with a
CertiFiber Pro OLTS module, this control lets you select an end of
the fiber so you can enter a name for the end (item
 ) and do
tests from that end of the fiber.