Fluke Networks CertiFiber Pro Users Manual - Manual (Page 361)

Chapter 14: Projects
How to Make ID Sets
339
4 Tap the Last ID panel, use the keyboard to enter the last ID for
the set, then tap DONE.
Note
If you do not enter a Last ID, the tester uses the
first ID as the Next ID and increments that ID each
time you save a result. See “About Next ID Sets”
on page 339.
5 To specify the tests that are necessary for each ID in the set,
select the tests under Select Fiber Tests. See Figure 125 on
page 318.
6 To see the ID set, tap REVIEW.
7 On the CABLE ID REVIEW screen or the CABLE ID SETUP
screen, tap Save.
About Next ID Sets
Next ID sets have one ID that the tester increments each time you
do a test. To make a Next ID set, do not enter a Last ID when you
make an ID set.
 Numbers increment sequentially:
1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, ... 99, 100, 101...
 Letters increment through the English alphabet:
A, B, C, D, ... Z, AA, AB, AC, AD, ... AZ, BA, BB, BC...
 Numbers and letters do not cause each other to increment:
1Y, 1Z, 1AA, 1AB, ... 1ZZ, 1AAA, 1AAB...
 The tester does not increment symbols or accented characters.
When you use a Next ID set, the set under IDs Untested on the
CHANGE ID screen shows only the next ID. To save the next test
with a different ID, tap the Next ID: panel, then enter a different
ID.
Each project can have one Next ID set.