How to enter text – Fluke Networks CertiFiber Pro Users Manual User Manual
Page 44
Versiv Cabling Certification Product Family
Technical Reference Handbook
22
RESULTS: Tap RESULTS to see and manage the results that are
saved in the tester.
TEST: Tap TEST to do the test shown in the test setup panel.
The percentage of the tests in the project that are completed.
The tester uses the number of available IDs and, for fiber tests,
the tests you selected on the CABLE ID SETUP screen to calculate
this percentage. See Figure 125 on page 318. % Tested does not
show if your project contains only a Next ID list. See “About Next
ID Sets” on page 339 for more information about the Next ID
list.
The type of module attached to the tester. If no module is
attached, this screen shows HOME.
How to Enter Text
When you tap a panel to enter text, a keyboard shows on the
bottom half of the display (Figure 7).
To enter characters, tap the characters on the keyboard.
To change the case of the letters, tap
.
To delete characters, tap
.
To move the cursor into a group of characters, tap on the
group.
To select a group of characters, double-tap on the group.
To enter accented letters, tap
, then tap the letters on
the keyboard. To enter non-accented letters, tap
again.
To save the text, tap DONE.