Fluke Networks CertiFiber Pro Users Manual - Manual (Page 172)

Versiv Cabling Certification Product Family
Technical Reference Handbook
150
How to Use a Fluke Networks IBC OneClick
Cleaner

Caution
To prevent damage to the device and to connectors
and to keep contamination off of endfaces, read all
instructions and obey all safety precautions given in
the instructions for the device you use to clean
connectors.
To clean the connectors on test reference cords, use
wipes, swabs, and solvent. The OneClick cleaner
cleans the fiber core, but can leave contamination
around the core. The contamination can move to
the core when you make connections. See “To Clean
Connector Ends” on page 154.
1 Use the video probe to inspect the connector. If it is dirty,
continue to step 2.
2 To clean a bulkhead connector, remove the cap. To clean the
connector on a fiber cable, remove only the tip of the cap.
3 If necessary for a bulkhead connector, extend the tip of the
device.
4 Push the device straight into the connector until you hear a
loud click. See Figure 72. Then remove the device.
5 Use the video probe to inspect the connector. If necessary,
clean and inspect the connector again.
If the mechanical device does not clean the connector
sufficiently, use a swab and solvent to clean the connector.