How to reset the nvp to the default value, How to make a custom fiber type – Fluke Networks CertiFiber Pro Users Manual User Manual
Page 370
Versiv Cabling Certification Product Family
Technical Reference Handbook
348
6
Tap MEASURE.
7
On the NVP screen, use
or
to change the NVP value
until the measured length is the length of the cable, then tap
SAVE.
How to Reset the NVP to the Default Value
To reset the NVP to the default value defined by the selected
cable type, select the cable type again on the TEST SETUP screen.
How to Make a Custom Fiber Type
If a fiber installation has a fiber type that is not in the list of types
in the tester, you can make a custom fiber type for the job. A
custom fiber type has these settings:
Custom fiber name
Category of fiber (OM categories for multimode, OS
categories for singlemode)
IOR (index of refraction)
Backscatter value for fiber types for OTDR tests
Use the values specified by the fiber manufacturer to make the
custom fiber type.
You can make up to 20 custom fiber types. The tester keeps
custom fiber types with the other fiber types in the main Versiv
unit (not in the module). The names of custom fiber types have an
asterisk (*) at the start and end.
To make a custom fiber type
1
On the home screen, tap the test setup panel.
2
On the CHANGE TEST screen, tap an OLTS or OTDR fiber test,
then tap EDIT.