Fluke Networks CertiFiber Pro Users Manual - Manual (Page 18)

xvi
Versiv Cabling Certification Product Family
Technical Reference Handbook
75. How to Remove and Install the Connector Adapters....161
76. The Home Screen for CertiFiber Pro Modules................162
77. How to Prevent Damage to the EF-TRC Fiber Cables ....169
78. Screen to Set the Number of Connectors,
Splices, and Jumpers........................................................175
79. How to Count the Numbers of Connectors, 
Splices, and Jumpers........................................................177
80. Equipment for Autotests in Smart Remote Mode .........179
81. Connections for Smart Remote Mode
(1 Jumper Reference, Multimode Fiber) ........................182
82. Result for Smart Remote Mode
(Unsaved Bi-Directional Results Shown).........................184
83. Detailed Result for Smart Remote Mode
(Unsaved Bi-Directional Results Shown).........................186
84. Unsaved and Saved Result for Smart Remote Mode.....189
85. Equipment for Autotests in Loopback Mode.................191
86. Connections for Loopback Mode
(1 Jumper Reference, Multimode Fiber) ........................193
87. Result for Loopback Mode..............................................196
88. Equipment for Autotests in Far End Source Mode........199
89. Connections for Far End Source Mode
(1 Jumper Reference, Multimode Fiber) ........................202
90. Result for Far End Source Mode .....................................205
91. Equipment for Power Meter Measurements .................210
92. Connections to Monitor Power and Loss .......................211
93. Power Meter Measurements and Controls ....................212
94. Light Source Controls for the Main Tester.....................215
95. Main Versiv Unit with OptiFiber Pro OTDR Module
(OptiFiber Pro Quad module shown) .............................218
96. The HOME Screen for OptiFiber Pro Modules ...............220
97. Connections for Launch Only Compensation.................229