Fluke Networks CertiFiber Pro Users Manual User Manual
Page 341
Chapter 14: Projects
Tutorial: Make a New Project
319
Notes
The Select Media section does not show for ID sets
that do not have a Last ID.
ID sets are available only for tests on the media
type you selected for the ID set.
Tap IMPORT to use an ID set that you downloaded to the tester
from LinkWare software.
Tap REVIEW to see the CABLE ID REVIEW screen, which shows
the ID set an the total number of IDs. See “How to Make ID Sets”
on page 337.
Note
The REVIEW button is not available if you do not
enter a Last ID.
SAVE: To save the ID set, tap SAVE.
When you select Fiber media for tests that use a CertiFiber Pro
or OptiFiber Pro module, select the tests that are necessary for
each fiber in the ID set.
For example, you can specify that you must do a Loss/Length
test and a FiberInspector test for each ID. After you do both
tests for all the IDs in the set, the tester shows 100% Tested on
the home screen. If no IDs include FiberInspector results, the
tester shows 50%. To see the IDs that need FiberInspector
results, select a FiberInspector test in the project, then look at
the list under FiberInspector IDs Untested on the CHANGE ID
screen (item
Note
When you select a test in the Fiber section, be sure
to add that test to the project. See “Step 3: Set up
Tests for the Project” on page 313.