Fluke Networks CertiFiber Pro Users Manual - Manual (Page 380)

Versiv Cabling Certification Product Family
Technical Reference Handbook
358
Verify Operation
The tester does a self test when you turn it on. If the tester shows
an error or does not turn on, refer to “If the Tester Does Not
Operate as Usual” on page 365.
Clean the Tester
To clean the touchscreen, turn off the tester, then use a soft, lint-
free cloth that is moist with water or water and a mild detergent.
To clean the case, use a soft cloth that is moist with water or
water and a mild detergent.

Warning

Do not put the tester or the battery pack in water.

Caution
To prevent damage to the touchscreen or the case,
do not use solvents or abrasive materials.
When you clean the touchscreen or the case, do not
let liquid get under the plastic around the
touchscreen.
To clean the connectors on an OTDR module, see the instructions
in Chapter 6.
See Information About the Tester
To see information about your tester and attached modules and
adapters
On the home screen, tap the TOOLS icon, then tap Version
Information. See Figure 132.
To see information about a remote tester
Use copper modules and adapters to connect the main and
remote testers together (see Figure 4 on page 16), then tap
REMOTE on the Version Information screen.