Fluke Networks CertiFiber Pro Users Manual - Manual (Page 11)

Contents
ix
Step 5: Give Names to the Ends of the
Fiber for OTDR Tests ................................................320
Step 6: Turn on the Auto Save Function .................320
Tutorial: How to Use a Project for Tests with a
CableAnalyzer Module ...................................................323
Step 1: Attach a CableAnalyzer Module .................323
Step 2: Select a Project .............................................323
Step 3: Select a Test for Twisted Pair Cable ............324
Step 4: Do an Autotest .............................................325
Step 5: Monitor the Status of Your Project ............325
Tutorial: How to Use a Project for Tests with
OptiFiber Pro and CertiFiber Pro Modules ....................326
Step 1: Attach an OptiFiber Pro Module .................328
Step 2: Select a Project .............................................328
Step 3: Select an OTDR Test .....................................328
Step 4: Select the Correct ID and Fiber End 
if Necessary ...............................................................328
Step 5: Do OTDR Tests on End 1 of the Link ...........329
Step 6: Do OTDR Tests on End 2 of the Link ...........329
Step 7: Add Results from a Loss/Length Test ..........330
Step 8: Monitor the Status of Your Project ............333
How to Change Settings as You Use a Project ..............333
To Change the ID .....................................................333
To Change the Tests in a Project .............................335
To Save Results in a Different or New Project ........337
How to Make ID Sets ......................................................337
About Next ID Sets ...................................................339
Import an ID Set into a Project ................................340
Delete an Imported ID Set .......................................341
How to Manage Projects ................................................341