Fluke Networks CertiFiber Pro Users Manual - Manual (Page 175)

Chapter 6: How to Clean Fiber Endfaces
How to Use Wipes, Swabs, and Solvent
153
To Clean the Optical Connectors on the Modules
To clean the optical connectors on the modules, first use the
procedure given under “To Clean Bulkhead Connectors”.
If a connector is very dirty or the procedure above does not make
it clean, use this procedure:
1 Unscrew the adapter on the connector.
2 Clean the ferrule or photodiode lens with a dry, optical-grade
wipe made for fiber optic connectors.
3 Use a video probe to inspect the connector. If necessary, clean
and inspect the connector again.
4 If the connector stays dirty, use a wipe that is moist with
optical-grade solvent to clean the endface. Dry the ferrule
with a dry wipe.
Note
If the OTDR Port Connection Quality gauge for
the OptiFiber Pro module stays in the Poor range
after you clean the OTDR connector, remove the
adapter from the module and inspect the adapter
for damage. Make sure that the white plastic ring
inside the center tube shows no damage.
To Clean Fiber Adapters
At regular intervals, clean fiber adapters with a swab and fiber
optic solvent. Dry with a dry swab.