Fluke Networks CertiFiber Pro Users Manual - Manual (Page 382)

Versiv Cabling Certification Product Family
Technical Reference Handbook
360
 Calibration Date is the date when the adapter was
calibrated at a Fluke Networks factory or service center.
 Autotest Count is the number of Autotests done with the
adapter. You can use this count to monitor the wear on
the adapter’s jack or plug.
 Current Series is an Autotest count that you can reset. To
reset the counter, tap Reset Series.
 Tap MODULE to see the Serial Number, Software version, and
Calibration Date of the attached module. The Calibration Date
is the date when the module was calibrated at a Fluke Networks
factory or service center.
Update the Software
New software gives you access to new features and the latest test
limits and cable types. Software updates are available on the
Fluke Networks website.
You can use a PC to install a software update, or connect an
updated main unit to a remote or to another main unit to update
those units.
To use a PC to update the software

Caution
To prevent unexpected loss of power, connect the
ac adapter to the tester when you update the
software.
Note
The software update procedure does not delete
the test records, project settings, or user
preferences in the tester, but can possibly change
the factory-installed cable types or test limits.
1 Install the latest version of LinkWare software on your PC.
LinkWare is available on the Fluke Networks website.