Fluke Networks CertiFiber Pro Users Manual - Manual (Page 337)

Chapter 14: Projects
Tutorial: Make a New Project
315
Step 4: Make ID Sets for Twisted Pair and Fiber Cabling
To see the CABLE ID SETUP screen
 On the home screen, tap the PROJECT panel, then tap NEW ID
SET on the PROJECT screen.
 Or, on the home screen, tap the Next ID panel, tap CHANGE
CABLE IDs, then tap NEW ID SET on the CHANGE CABLE IDs
screen (see Figure 124 on page 317).
When you make cable ID sets, you set up these items for the
project (see Figure 125 on page 318):
 Sets of IDs to use when you save test results. For example, you
can make one set of IDs for multimode fibers and another for
twisted pair copper cables.
 For projects that use an OptiFiber Pro or CertiFiber Pro
module, you specify the tests to do for each ID. As you use the
project, the tester shows the percentage of the necessary tests
you have completed. It also shows the IDs that do not have
results for each test.
For this tutorial, your project will include ID sets for 12 twisted
pair cables and 10 fiber optic cables (5 duplex fiber links). It is not
necessary to attach a copper or fiber module before you set up an
ID set for that module.
To make a cable ID set for tests on twisted pair cabling
4-1 On the home screen, tap the PROJECT panel, then tap NEW
ID SET on the PROJECT screen.
4-2. For this tutorial, you will make an ID set that has 12 IDs for
twisted pair cabling:
a. On the CABLE ID SETUP screen (Figure 125 on page 318), tap
the box under First ID, use the keyboard to enter B-00.
b. Tap the box under Last ID, use the keyboard to enter D-03,
then tap DONE.
(continued)