CANOGA PERKINS CanogaOS Command Reference - Manual (Page 848)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 848 of 855
45 Sflow Commands
45.1 sflow enable
Use this command to enable or disable sFlow globally.
Command Syntax
(no|)sflow enable
sflow: Sampled flow
enable: Enable sFlow services
Command Mode
Global configuration mode
Usage
Before any other sFlow command can be configured, sFlow services must be enabled globally. Use the no
parameter with this command to remove all sFlow configurations and disable sFlow globally.
Examples
This example shows how to enable sFlow services globally.
Switch# configure terminal
Switch (config)# sflow enable
Related Commands
45.2 sflow collector
Use this command to configure sFlow collector.
Command Syntax
(no|) sflow collector (<1-65535>|)
sflow: Sampled flow
collector: Set sFlow collector
A.B.C.D: Collector IP address
<1-65535>: Collector UDP port number, default is 6343
Command Mode
Global configuration mode
Usage
Use this command to add a collector by specifying the combination of IP address and UDP port. Only up to