CANOGA PERKINS CanogaOS Command Reference - Manual (Page 209)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 209 of 855
reset the action. .
Command Syntax
ethernet oam link-monitor remote-failure critical-event|dying-gasp|link-fault
action error-disable-interface
no ethernet oam link-monitor remote-failure
critical-event|dying-gasp|link-fault action error-disable-interface
Command Mode
Interface mode
Default
Remote failure does not trigger any interface events by default.
Examples
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# ethernet oam remote-failure critical-event action
errordisable-interface
11.11 ethernet oam remote-loopback
Use this command to configure remote loopback on a interface. This command can be used to enable or
disable remote loopback and also configure the remote loopback timeout, which is the number of
seconds the DTE will wait for the remote DTE to respond to the ethernet oam remote-loopback enable
command. Use the no form of this command to remove remote-loopback support from the interface.
Command syntax
ethernet oam remote-loopback supported | timeout SECS
no ethernet oam remote-loopback supported | timeout
supported Remote loopback can be initiated in the DTE
timeout Configure the timeout for remote loopback in seconds
SECS The remote loopback timeout value in the range of <1-10>
Command Mode
Interface mode
Default
The default state for the remote loopback is not supported. If a timeout is not configured, the local DTE
remains in remote loopback state until the remote DTE responds or the user stops remote loopback