CANOGA PERKINS CanogaOS Command Reference - Manual (Page 434)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 434 of 855
Usage
This command is used to create or delete mvr source vlan ip address. The default IP address is
10.0.0.1
Examples
Create mvr source address
Switch(config)# mvr source-address 192.168.11.1
Resume mvr source address as 10.0.0.1
Switch(config)# no mvr source-address
Related Commands
None
23.5 mvr type
Use this command to configure a switch-port as source port or receiver port.
Command Syntax
mvr type {source | receiver vlan vlan}
no mvr type [receiver vlan vlan]
source: An MVR source port
receiver: An MVR receiver port
vlan: <1-4094> A receiver vlan
Command Mode
Interface configure
Usage
Configure the interface as source port or receiver port. The source port must belong to source vlan,
and the receiver port must not belong to source vlan.
Examples
Configure the eth-0-1 as source port, and configure the eth-0-2 as receiver port of vlan 2
Switch(config)#interface eth-0-1
Switch(config-if)#mvr type source
Switch(config)#interface eth-0-2
Switch(config-if)#mvr type receiver vlan 2
Related Commands
None