CANOGA PERKINS CanogaOS Command Reference - Manual (Page 122)

CanogaOS Command Line Reference
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 122 of 855
group-id: <0-31> VLAN classifier group id
{ip|mac|protocol}: based on ip or mac or protocol
Command Mode
Interface configuration
Usage
An interface can only be applied by one vlan classifier group.
One vlan classifier group can apply more than one interface.
This command apply vlan classifier group to interface, and the interface can classify packets to
different vlan according to the rule in vlan classifier group.
To create the rule, reference to vlan classifier rule command.
To create the group, reference to vlan classifier group command.
Examples
This example shows how to apply vlan classifier group 1 to the interface:
Switch(config-if)# vlan classifier activate 1 based ip
This example shows how to remove the vlan classifier group 1 from the interface:
Switch(config-if)# no vlan classifier activate
Related Commands
vlan classifier group
vlan classifier rule
6.10 vlan classifier group
Use this command to add or delete rule to vlan classifier group.
To remove the group, use the no form of this command.
Command Syntax
vlan classifier group group {add|delete} rule rule
group: <0-31> the id of vlan classifier group
{add|delete}: add or delete rule to vlan classifier group
rule: the id of rule
Command Mode
Global configuration
Usage
To create the rule, reference to vlan classifier rule command.
To apply the vlan classifier group to an interface, reference to vlan classifier activate command.
When add a rule to the group by this command, the rule will be active even if the group has been apply