CANOGA PERKINS CanogaOS Command Reference - Manual (Page 207)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 207 of 855
ethernet oam link-monitor frame threshold high HIGH_THRES|none low LOW_THRES window WINDOW
no ethernet oam link-monitor frame threshold high|low|window
none No high threshold value is set
HIGH_THRES Value of the high threshold for errored frames in the range of <1-65535
LOW_THRES Value of the low threshold for errored frames in the range <0-65535>
WINDOW Size of frame event window, expressed in milliseconds, in multiples of 100, in the range
<100-600> s
Command Mode
Interface mode
Default
The default value for high threshold is none, meaning that no high threshold is configured. The default
value of low threshold is 1.
The default value for the frame event window is 100.
Examples
Switch# configure terminal
Switch (config)# interface eth-0-1
Switch (config-if)# ethernet oam link-monitor frame threshold high 5 low 2 window 200
11.8 ethernet oam link-monitor frame-seconds threshold
Use this command to configure the low and high threshold and the window for the frame-seconds event.
If the low threshold is exceeded, an errored-frame-seconds link event is generated. If the high threshold
is exceeded then action defined through the command ethernet oam link-monitor high threshold action
will be taken
Command Syntax
ethernet oam link-monitor frame-seconds threshold high HIGH_THRES|none low
LOW_THRES window WINDOW
no ethernet oam link-monitor frame-seconds threshold high low window
HIGH_THRES High threshold for the number of errored frame-seconds in the range of <1-900>
LOW_THRES Low threshold for the number of errored frame-seconds <1-900>
WINDOW Window for frame-seconds events, in milliseconds, in multiples of 100, in the range
<100-900>.