CANOGA PERKINS CanogaOS Command Reference - Manual (Page 814)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 814 of 855
This example shows how to set the mirror source to vlan2 in session 1 to monitor received traffic only.
Switch(config)# monitor session 1 source vlan 2 rx
This example shows how to cancel the mirror source vlan 2 in session 1.
Switch(config)# no monitor session 1 source vlan 2 both
Related Commands
monitor session destination
show monitor
41.4 show monitor
Use this command to show the information about monitor.
Command Syntax
show monitor [session <session>]
session: mirror session number
Command Mode
EXEC
Usage
None
Examples
This example shows how to display the information about monitor.
Switch#show monitor
Session 1
----------
Status : Valid
Source Ports :
Receive Only :
Transmit Only :
Both : eth-0-2 eth-0-3
Source VLANs :
Receive Only :
Transmit Only :
Both : 2
Destination Port : eth-0-1
Related Commands
monitor session source interface
monitor session source vlan
monitor session destination