CANOGA PERKINS CanogaOS Command Reference - Manual (Page 714)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 714 of 855
Command Syntax
dot1x timeout {reauth-period seconds | server-timeout seconds | supp-timeout seconds |
tx-period seconds}
no dot1x timeout {reauth-period | server-timeout | supp-timeout | tx-period}
reauth-period seconds Set the number of seconds between re-authentication attempts.
The number of seconds from 1 to 65535; the default is 3600
seconds.
server-timeout seconds Number of seconds that the switch waits for the retransmission
of packets by the switch to the authentication server. The range
is 1 to 65535.
supp-timeout seconds Number of seconds that the switch waits for the retransmission
of packets by the switch to the IEEE 802.1x client. The range is
1 to 65535.
tx-period seconds Number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before retransmitting
the request. The range is 1 to 65535.
Default
These are the default settings:
reauth-period is 3600 seconds.
tx-period is 30 seconds.
supp-timeout is 30 seconds.
server-timeout is 30 seconds.
Command Mode
Interface configuration
Usage
You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
The dot1x timeout reauth-period interface configuration command affects the behavior of the switch
only if you have enabled periodic re-authentication by using the dot1x reauthentication interface
configuration command.
Examples
The following is sample output from the dot1x timeout command:
Switch(config-if)# dot1x reauthentication
Switch(config-if)# dot1x timeout reauth-period 4000
Related Commands
show dot1x