CANOGA PERKINS CanogaOS Command Reference - Manual (Page 711)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 711 of 855
Interface configuration
Usage
You must globally enable IEEE 802.1x authentication on the switch by using the dot1x
system-auth-control global configuration command before enabling IEEE 802.1x authentication on a
specific port.
Examples
The following is sample output from the dot1x port-control command:
Switch(config-if)# dot1x port-control auto
Related Commands
show dot1x
37.4 dot1x protocol-version
Use the dot1x max-reauth-req interface configuration command on the switch to set the version of
EAPOL packets. Use the no form of this command to return to the default setting.
Command Syntax
dot1x protocol-version version
no dot1x protocol-version
version The EAPOL version. Default is 2.
Default
The default is version 2.
Command Mode
Interface configuration
Usage
You must specify the control of the authorization state of the port by the dot1x port-control command,
before setting the EAPOL version.
Examples
The following is sample output from the dot1x protocol-version command:
Switch(config-if)# dot1x protocol-version 1
Related Commands
show dot1x