CANOGA PERKINS CanogaOS Command Reference - Manual (Page 276)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 276 of 855
15.40 show ip ospf virtual-links
To display parameters and the current state of Open Shortest Path First (OSPF) virtual links, use the
show ip ospf virtual-links command in EXEC mode.
Command Syntax
show ip ospf virtual-links
Command Mode
EXEC
Usage
The information displayed by the show ip ospf virtual-links command is useful in debugging OSPF
routing operations.
Examples
The following is sample output from the show ip ospf virtual-links command:
Switch# show ip ospf virtual-links
Virtual Link VLINK0 to router 3.3.3.3 is down
Transit area 1 via interface *
Local address *
Remote address *
Transmit Delay is 1 sec, State Down,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in inactive
Adjacency state Down
Related Commands
15.41 timers spf
To turn on Open Shortest Path First (OSPF) shortest path first (SPF) throttling, use the timers spf
command in router configuration mode. To turn off SPF throttling, use the no form of this command.
Command Syntax
timers spf spf-start spf-hold
no timers spf
spf-start Indicates the initial SPF schedule delay in seconds. Value range is 0 to
2147483647 seconds.
spf-hold Indicates the minimum hold time between two consecutive SPF calculations.
Value range is 0 to 2147483647 seconds.