CANOGA PERKINS CanogaOS Command Reference - Manual (Page 173)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 173 of 855
edge: edge port
common: common port
interface: physical or aggregator interface
IF_NAME: interface name
Command Mode
Global configuration
Usage
This common is only available for edge/assistant-edge node.
Examples
This example shows how to set interface eth-0-9 as edge interface for ERPS domain 11 ring 1.
Switch#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#interface eth-0-9
Switch(config-if)#switchport mode trunk
Switch(config-if)#switchport trunk allowed vlan add 15
Switch(config-if)#exit
Switch(config)#erps 11 ring 1 edge interface eth-0-9
And you can check the result by using “show erps 11” command.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16
ERPS domain sub control VLAN ID: 15
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 5 second(s)
ERPS ring ID: 1
ERPS ring level: sub
ERPS ring 1 node mode: transit
ERPS ring 1 edge node mode: edge
ERPS ring 1 node state: idle
ERPS ring 1 edge interface name: eth-0-9
ERPS ring 1 common interface name: not configured
EPRS ring 1 SRPT is enabled
Related Commands
None