CANOGA PERKINS CanogaOS Command Reference - Manual (Page 402)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 402 of 855
20
VRF Commands
VRF is routing and forwarding table associated with one or more directly connected VPN sites(CE routers to
PE routers).
20.1 (no) ip vrf
To configure a VPN routing and forwarding(VRF) routing table, use the ip vrf command in global configuration
mode. To remove a VRF routing table, use the no form of this command.
Command Syntax
ip vrf VRF-NAME
no ip vrf VRF-NAME
VRF-NAME: VPN Routing/Forwarding instance name
Command Mode
Global configuration mode
Usage
This example shows how to add a vrf named ComA
Switch# configure terminal
Switch(config)# ip vrf ComA
And you can get the result by use show ip vrf command.
Switch#show ip vrf
VRF ComA, FIB ID 1
Router ID is not set
Interfaces:
!
VRF ComA; (id=1); RIP is not enabled
Name Interfaces
ComA
Name Default RD Interfaces
ComA
Examples
Switch(config)#ip vrf ComA
Switch(config-vrf)#route-target both 100:2
Switch(config-vrf)#route-target import 200:1
Related Commands
ip vrf forwarding Associates a VRF with a Layer3 interface