CANOGA PERKINS CanogaOS Command Reference - Manual (Page 653)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 653 of 855
Command Mode
Interface configuration
Usage
A policer specifies the bandwidth limits for the traffic. Packets that exceed the limits should be out of
profile (exceed CIR) or nonconforming (exceed PIR).
Examples
Configure a port-policing to ingress of eth-0-1
Switch(config)#interface eth-0-1
Switch(config-if)#port-policer ingress color-aware cir 200000 cbs 30000 pir 400000 pbs 40000
drop-color red
Remove port-policing from ingress of eth-0-1
Switch(config-if)#no port-policer ingress
Related Commands
None
32.41 service-policy
Use this command to configure a policy for interface to match the traffic defined by class-map, do
according actions.
Command Syntax
(no)service-policy (input | output) NAME
Service-policy: Configure QoS Service Policy
input: Assign policy-map to the input of an interface
output: Assign policy-map to the output of an interface
NAME: Specify a policy-map name
Command Mode
Interface configuration
Usage
Use the service-policy interface configuration command to apply a policy map defined by the
policy-map command to the input or output of a particular interface. Use the no form of this command
to remove the policy map and interface association.
Examples
Configure a policy to ingress of a physical interface
Switch(config)#interface eth-0-1
Switch(config-if)#service-policy input plc_map1