CANOGA PERKINS CanogaOS Command Reference - Manual (Page 316)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 316 of 855
16.57 neighbor override-capability
Use this command to override a capability negotiation result.
Use the no parameter with this command to disable this function
Command Syntax
(no) neighbor NEIGHBORID override-capability
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group.
For information on how to create peer groups, refer to the neighbor peer-group and neighbor remote-as
commands. When this parameter is used with a command, the command applies on all peers in the
specified group.
Command Mode
Router mode
Examples
Switch# configure terminal
Switch(config)# router bgp 12
Switch(config-router)# neighbor 10.10.10.10 override-capability
16.58 neighbor passive
Use this command to set a BGP neighbor as passive.
Use the no parameter with this command to disable this function
Command Syntax
(no) neighbor NEIGHBORID passive
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group. For information on how to create peer groups, refer to the
neighbor peer-group and neighbor remote-as commands. When this parameter is used with a
command, the command applies on all peers in the specified group.
Command Mode
Router mode
Examples