CANOGA PERKINS CanogaOS Command Reference - Manual (Page 784)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 784 of 855
40.52 debug pim sparse-mode
To display Protocol Independent Multicast (PIM) packets received and sent, and to display PIM-related
events, use the debug pim command in privileged EXEC mode. To disable debugging output, use the
no form of this command.
Command Syntax
debug pim sparse-mode {all | events | mfc | mib | mtrace | nexthop | nsm | packet | state | timer}
no debug pim sparse-mode {all | events | mfc | mib | mtrace | nexthop | nsm | packet | state |
timer}
all All PIM debugging.
events PIM events.
mfc PIM MFC updates.
mib PIM mib.
mtrace Mtrace messages.
nexthop PIM nexthop.
nsm NSM message.
packet PIM packet.
state PIM state.
timer PIM timers.
Command Mode
Privileged EXEC
Usage
PIM uses Internet Group Management Protocol (IGMP) packets to communicate with switches and
advertise reachability information.
Use this command with the debug igmp commands to display additional multicast routing information.
Examples
The following is sample output from the debug pim sparse-mode command:
Switch# debug pim sparse-mode
Related Commands
debug igmp
40.53 show debugging
To display information about the types of debugging that are enabled for your switch, use the show
debugging command in privileged EXEC mode.