CANOGA PERKINS CanogaOS Command Reference - Manual (Page 174)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 174 of 855
8.9 erps ring srpt
Use this command to enable/disable srpt functionality for specific ERPS ring instance.
Command Syntax
erps ERPS_ID ring RING_ID srpt {enable|disable}
ERPS_ID : <1-255> ERPS domain ID
RING_ID : <1-255> ERPS ring ID
enable: enable the srpt
disable: disable the srpt
Command Mode
Global configuration
Usage
This command is only available for edge node.
Examples
This example shows how to disable srpt functionality for ERPS domain 11 ring 1.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#erps 11 ring 1 srpt disable
And you can check the result by using “show erps 11” command.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16
ERPS domain sub control VLAN ID: 15
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 5 second(s)
ERPS ring ID: 1
ERPS ring level: sub
ERPS ring 1 node mode: transit
ERPS ring 1 edge node mode: edge
ERPS ring 1 node state: idle
ERPS ring 1 edge interface name: eth-0-9
ERPS ring 1 common interface name: eth-0-13
EPRS ring 1 SRPT is disabled
Related Commands
None