CANOGA PERKINS CanogaOS Command Reference - Manual (Page 581)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 581 of 855
28.25.1.4 Defaults
No set origin is specified by default.
28.25.1.5 Examples
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3
Switch(config-route-map)# set origin egp
28.25.1.6 Related Commands
28.26 set originator-id
Use this command to set the originator ID attribute.
Use the no parameter with this command to disable this function
To use the set originator-id command, you must first have a match clause. Match and set
commands set the conditions for redistributing routes from one routing protocol to another. The
match command specifies the match criteria under which redistribution is allowed for the
current route-map. The set command specifies the set redistribution actions to be performed, if
the match criteria are met.
If the packets do not match any of the defined criteria, they are routed through the normal
routing process.
Note:
This command is valid for BGP only.
28.26.1.1 Command Syntax
set originator-id IPADDRESS
no set originator-id
28.26.1.2 Syntax Description
IPADDRESS Specifies the IP address of originator.
28.26.1.3 Command Mode
Route-map mode