CANOGA PERKINS CanogaOS Command Reference - Manual (Page 573)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 573 of 855
AA = The AS number.
NN = The number assigned to community.
internet Specifies the Internet (well-known community).
local-AS Specifies no sending outside the local AS (well-known
community).
no-advertise Specifies no advertisement of this route to any peer
(well-known community).
no-export Specifies no advertisement of this route to next AS
(well-known community).
none Removes the community attribute from the prefixes that
pass the route-map.
additive Adds to the existing community.
28.18.1.3 Command Mode
Route-map mode
28.18.1.4 Defaults
No set community is specified by default.
28.18.1.5 Examples
The following examples show the use of the set community command with different
parameters.
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3
Switch(config-route-map)# set community no-export no-advertise
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3
Switch(config-route-map)# set community no-advertise
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3
Switch(config-route-map)# set community 10:01 23:34 12:14 no-export
28.18.1.6 Related Commands
28.19 set dampening
Use this command to enable route-flap dampening and set parameters.
Use the no parameter with this command to disable it.
Set the unreachability half-life time to be equal to, or greater than, reachability half-life time.