CANOGA PERKINS CanogaOS Command Reference - Manual (Page 65)

CanogaOS Command Line Reference
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 65 of 855
4.10 description
Use this command to set the description on the interface.
To remove the description on the interface, use the no form of this command.
Command Syntax
description line
no description
line: the description on the interface
Command Mode
Interface configuration
Usage
There is no description on the interface by default.
Examples
The following example sets the description on the interface.
Switch(config-if)# description the type of interface is Ethernet
The following example removes the description on the interface.
Switch(config-if)# no description
Related Commands
None
4.11 duplex
Use the duplex interface configuration command to specify the duplex mode of operation for a port. Use
the no form of this command to return the port to its default value.
Command Syntax
duplex {auto |full |half}
no duplex
auto: Enable automatic duplex configuration; port automatically detects whether it should run in full-
or half-duplex mode, depending on the attached device mode.
full: Enable full-duplex mode.
half: Enable half-duplex mode (only for interfaces operating at 10 or 100 Mb/s). You
cannot configure half-duplex mode for interfaces operating at 1000 or
10,000 Mb/s.