CANOGA PERKINS CanogaOS Command Reference - Manual (Page 129)

CanogaOS Command Line Reference
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 129 of 855
Command Syntax
switchport trunk allowed vlan {add vlan ｜remove vlan| all | none}
no switchport trunk
vlan: vlan list connected with ‘-’ and ‘,’, for example, “1-10,15,20,30-40”
add: allow the traffic from the specified vlan to transmit the trunk port
remove: do not allow the traffic from the specified vlan to transmit the trunk port
all: allow the traffic from all the vlan to transmit the trunk port
none: do not allow the traffic from all the vlan to transmit the trunk port
Command Mode
Interface configuration
Usage
None
Examples
This example shows how to allow traffic from vlan11,12 to transmit the trunk port
Switch(config-if)# switchport trunk allowed vlan add 11,12
This example shows how to refuse traffic from vlan11,12 to transmit the trunk port
Switch(config-if)# switchport trunk allowed vlan remove 11,12
This example shows how to allow traffic from all vlan to transmit the trunk port
Switch(config-if)# switchport trunk allowed vlan all
This example shows how to refuse traffic from all vlan to transmit the trunk port
Switch(config-if)# switchport trunk allowed vlan none
Related Commands
switchport access allowed
6.21 switchport trunk native
Use this command to set the native vlan for sending and receiving untagged traffic.
To return the native vlan to default value, use the no form of this command.
Command Syntax
switchport trunk native vlan vlan
no switchport trunk native vlan
vlan: <2-4094> an existing vlan id
Command Mode
Interface configuration