CANOGA PERKINS CanogaOS Command Reference - Manual (Page 172)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 172 of 855
Command Mode
Global configuration
Usage
Once a node is set to edge/assistant-edge node, it will be set to transit node automatically.
Examples
This example shows how to set node as ERPS domain 11 ring 1 edge node.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# erps 11 ring 1 edge-mode edge
And you can check the result by using “show erps 11” command.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16
ERPS domain sub control VLAN ID: 15
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 5 second(s)
ERPS ring ID: 1
ERPS ring level: sub
ERPS ring 1 node mode: transit
ERPS ring 1 edge node mode: edge
ERPS ring 1 node state: idle
ERPS ring 1 edge interface name: not configured
ERPS ring 1 common interface name: not configured
EPRS ring 1 SRPT is enabled
Related Commands
None
8.8 erps ring edge | common interface
Use this command to set/unset edge or common interface for specific ERPS ring instance.
Command Syntax
erps ERPS_ID ring RING_ID {edge | common} interface IF_NAME
no erps <1-255> ring RING_ID {edge | common} interface
ERPS_ID : <1-255> ERPS domain ID
RING_ID : <1-255> ERPS ring ID