CANOGA PERKINS CanogaOS Command Reference - Manual (Page 56)

CanogaOS Command Line Reference
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 56 of 855
Command Syntax
enable password {password | 8 encrypted-password}
no enable password
password Password users type to enter enable mode.
8 Specify the encrypted password.
Encrypted-password Encrypted password you enter, copied from another switch
configuration.
Default
No password is defined.
Command Mode
Global configuration
Usage
You will not ordinarily enter an encryption type. Typically you enter an encryption type only if you copy
and paste into this command a password that has already been encrypted by a switch.
Examples
The following example enables the password “abcd”:
Switch(config)# enable password abcd
The following example sets the encrypted password “6c8fddf03f120287”, which has been copied from
a switch configuration file, encryption type 8:
Switch(config)# enable password 8 6c8fddf03f120287
Related Commands
cipher detect
service password-encryption
3.11 enable secret
To set a local encrypted password to control access to various privilege levels, use the enable secret
command in global configuration mode.
Command Syntax
enable secret password
password Assign the privileged level secret.
Default
No password is defined.