CANOGA PERKINS CanogaOS Command Reference - Manual (Page 69)

CanogaOS Command Line Reference
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 69 of 855
The following example shows how to enable a port.
Switch(config-if)# no shutdown
Related Commands
None
4.16 speed
Use the speed interface configuration command to specify the speed of a 10/100 Mb/s or 10/100/1000
Mb/s port. Use the no or default form of this command to return the port to its default value.
Command Syntax
speed {10 |100 |1000 |auto}
no speed
10: Port runs at 10 Mb/s.
100: Port runs at 100 Mb/s.
1000: Port runs at 1000 Mb/s.
auto: Port automatically detects the speed it should run.
Command Mode
Interface configuration
Defaults
auto
Usage
The command is not allowed to be set on 10G port or optical mode of combo port.
Examples
This example shows how to set the speed on a port to 1000 Mb/s:
Switch(config-if)# speed 1000
This example shows how to return the speed on a port to default value:
Switch(config-if)# no speed
Related Commands
bandwidth
duplex