CANOGA PERKINS CanogaOS Command Reference - Manual (Page 50)

CanogaOS Command Line Reference
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 50 of 855
3.3 end
To end the current configuration session and return to privileged EXEC mode, use the end command
in global configuration mode.
Command Syntax
end
Command Mode
Global configuration
Usage
This command will bring you back to privileged EXEC mode regardless of what configuration mode or
configuration submode you are in.
Note This global configuration command can be used in any configuration mode.
Use this command when you are done configuring the system and you want to return to EXEC mode to
perform verification steps.
Examples
In the following example, the end command is used to exit from interface configuration mode and
return to privileged EXEC mode. A show command is used in privileged EXEC mode to verify the
configuration.
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# end
Switch# show interface eth-0-1
Related Commands
exit
3.4 exit (global)
To exit any configuration mode to the next highest mode in the CLI mode hierarchy, use the exit
command in any configuration mode.
Command Syntax
exit
Command Mode
All configuration modes