CANOGA PERKINS CanogaOS Command Reference - Manual (Page 325)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 325 of 855
Switch(config)# router bgp 12
Switch(config-router)# neighbor 10.10.10.10 timers 60 120
Switch(config-router)# neighbor 10.10.10.10 timers connect 10
16.70 neighbor unsuppress-map
Use this command to selectively leak more-specific routes to a particular neighbor.
Command Syntax
(no)neighbor NEIGHBORID unsuppress-map WORD
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group. For information on how to create peer groups, refer to the
neighbor peer-group and neighbor remote-as commands. When this parameter is used
with a command, the command applies on all peers in the specified group.
WORD The name of the route-map used to select routes to be unsuppressed.
Command Mode
Router mode and Address Family (ipv4 unicast | ipv4 multicast | ipv6) mode
Usage
When the aggregate-address command is used with the summary-only option, the more-specific routes of the
aggregate are suppressed to all neighbors. Use the unsuppress-map command to selectively leak
more-specific routes to a particular neighbor.
Example
Switch# configure terminal
Switch(config)# router bgp 10
Switch(config-router) neighbor 10.10.0.73 unsuppress-map mymap
Switch#configure terminal
Switch(config)#router bgp 10
Switch(config-router)address-family ipv4 unicast
Switch(config-router-af)neighbor 10.10.0.70 unsuppress-map mymap
16.71 neighbor update-source
Use this command to allow internal BGP sessions to use any operational interface for TCP connections.
Use the no parameter with this command to restore the interface assignment to the closest interface.