CANOGA PERKINS CanogaOS Command Reference - Manual (Page 66)

CanogaOS Command Line Reference
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 66 of 855
Command Mode
Interface configuration
Defaults
auto
Usage
The command is not allowed to be set on 10G port or optical mode of combo port.
Examples
The following example sets the duplex mode to auto.
Switch(config-if)# duplex auto
The following example sets the duplex mode to full.
Switch(config-if)# duplex full
The following example returns the duplex mode to default.
Switch(config-if)# no duplex
Related Commands
bandwidth
speed
4.12 interface
Use this command to enter interface mode.
Command Syntax
interface interface
interface: the name of port, i.e. eth-0-1, agg1, vlan1
Command Mode
Global configuration
Usage
The interface name can be either a port name (i.e. eth-0-1) or link-agg name (i.e. agg1) or vlan name (i.e.
vlan2).
Examples
The following example enters the interface mode for eth-0-1.
Switch(config)# interface eth-0-1
Switch(config-if)#