CANOGA PERKINS CanogaOS Command Reference - Manual (Page 72)

CanogaOS Command Line Reference
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 72 of 855
4.20 show interface
Use this command to display the configurations and statistics on all interface or an interface.
Command Syntax
show interface {IFNAME|}
IFNAME: the name of interface.
Command Mode
EXEC
Usage
None
Examples
This example shows how to display the configurations and statistics on the interface eth-0-1.
Switch# show interface eth-0-1
Interface eth-0-1
Interface current state: Administratively DOWN
Hardware is Ethernet, address is bc3e.60b2.1601 (bia bc3e.60b2.1601)
Bandwidth 1000000 kbits
Index 1 , Metric 1 , Encapsulation ARPA , loopback not set
Speed - 1000Mb/s , Duplex - Full , Media type is 1000BASE_T
Link speed type is autonegotiation, Link duplex type is autonegotiation
Input flow-control is off, output flow-control is off
The Maximum Frame Size is 1534 bytes
VRF binding: not bound
Label switching is disabled
No virtual circuit configured
ARP timeout 01:00:00, ARP retry interval 1s
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Received 0 broadcasts (0 multicast)
0 runts, 0 giants, 0 input errors, 0 CRC
0 frame, 0 overrun, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 late collision
0 no carrier, 0 pause output
Related Commands