CANOGA PERKINS CanogaOS Command Reference - Manual (Page 391)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 391 of 855
Switch (config)# route-map rmap1 permit 3
Switch (config-route-map)# set extcommunity rt 06:01
Switch # configure terminal
Switch (config)# route-map rmap1 permit 3
Switch (config-route-map)# set extcommunity rt 0.0.0.6:01
Switch # configure terminal
Switch (config)# route-map rmap1 permit 3
Switch (config-route-map)# set extcommunity soo 06:01
Switch # configure terminal
Switch (config-route-map)# route-map rmap1 permit 3
Switch (config-route-map)# set extcommunity soo 0.0.0.6:01
19.20.1.6 Related Commands
19.21 set ip next-hop
Use this command to set the specified next-hop value.
Use the no parameter with this command to turn off the setting.
Use this command to set the next-hop IP address to the routes.
Note:
This command is valid for BGP, OSPF, and RIP only.
19.21.1.1 Command Syntax
set ip next-hop A.B.C.D
no set ip next-hop
19.21.1.2 Syntax Description
A.B.C.D Specifies the IP address of the next-hop.
19.21.1.3 Command Mode
Route-map mode
19.21.1.4 Defaults
No set ip next-hop is specified by default.