CANOGA PERKINS CanogaOS Command Reference - Manual (Page 444)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 444 of 855
Command Mode
Interface configuration
Usage
None
Examples
This example shows how to establish neighbors based on access-list acl1.
Switch(config-if)#ip pim neighbor-filter acl1
This example shows how to cancel the filter.
Switch(config-if)#no ip pim neighbor-filter
Related Commands
None
24.11 ip pim register-rate-limit
Use this command to set the rate limit for pim registers.
To return the rate limit to default value, use the no form of this command.
Command Syntax
ip pim register-rate-limit <1-65535>
no ip pim register-rate-limit
<1-65535>: the rate limit for pim registers send from dr to rp
Command Mode
Global configuration
Usage
There is no rate limit for pim registers by default.
When the rate limit is configured, the exceed pim register message will be dropped on the rp.
Examples
This example shows how to set the rate limit for pim registers to 100 per second.
Switch(config)#ip pim register-rate-limit 100
This example shows how to cancel the rate limit.
Switch(config)#no ip pim register-rate-limit
Related Commands
ip pim register-rp-reachability
ip pim register-source
ip pim register-suppression