CANOGA PERKINS CanogaOS Command Reference - Manual (Page 138)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 138 of 855
Default
By default, the bridge sends BPDUs to CPU.
Usage
This command can only be set when spanning tree protocol is disabled globally. And if spanning tree
protocol set to enabled, the bpdu-transparent state must be set to disabled.
Examples
Switch# configure terminal
Switch(config)# spanning-tree bpdu-transparent enable
Related Commands
7.12 spanning-tree port
Use this command to set the port enable or disable spanning tree protocol. The default state is
enabled.
Command Syntax
spanning-tree port {enable | disable}
enable Enable spanning protocol on this port.
disable Disable spanning protocol on this port.
Command Mode
Interface mode
Default
The default spanning tree state of the port is enabled.
Usage
Examples
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# spanning-tree port enable
Related Commands
7.13 spanning-tree port-priority
Use this command to set the port priority for a bridge. A lower priority indicates a greater likelihood of