CANOGA PERKINS CanogaOS Command Reference - Manual (Page 575)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 575 of 855
28.19.1.6 Related Commands
28.20 set extcommunity
Use this command to set an extended community attribute.
Use the no parameter with this command to disable this function
To use the set extcommunity command, you must first have a match clause. Match and set
commands set the conditions for redistributing routes from one routing protocol to another. The
match command specifies the match criteria under which redistribution is allowed for the
current route-map. The set command specifies the set redistribution actions to be performed, if
the match criteria are met.
If the packets do not match any of the defined criteria, they are routed through the normal
routing process.
Note:
This command is valid for BGP only.
28.20.1.1 Command Syntax
set extcommunity { rt | soo} EXTCOMMNUMBER […EXTCOMMNUMBER ]
no set extcommunity { rt | soo}
28.20.1.2 Syntax Description
rt Specifies the route target of the extended community.
soo Specifies the site-of-origin of the extended community.
EXTCOMMNUMBER ASN:nn_or_IP-address:nn VPN extended community.
ASN:nn
the AS number.
IPADDRESS:nn the AS number in IP address form.
28.20.1.3 Command Mode
Route-map mode
28.20.1.4 Defaults
No set extcommunity is specified by default.
28.20.1.5 Examples
Switch# configure terminal