CANOGA PERKINS CanogaOS Command Reference - Manual (Page 230)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 230 of 855
Default
This command is disabled by default.
Command Mode
Interface configuration
Usage
Use this command to override the default behavior of RIP as specified by the version command. This
command applies only to the interface being configured. You can configure the interface to send both
RIP versions.
Examples
The following example configures the interface to send both RIP Version 1 and Version 2 packets:
Switch(config-if)# ip rip send version 1 2
Related Commands
ip rip receive version
14.9 ip rip send-packet
To enable the interface to send Routing Information Protocol (RIP) packets, use the ip rip
send-packet command in interface configuration mode. To disable to send RIP packets, use the no
form of this command.
Command Syntax
ip rip send-packet
no ip rip send-packet
Default
This command is enabled by default.
Command Mode
Interface configuration
Usage
Use this command to enable or disable the capability of sending RIP packets, whether the network of
this interface is added into RIP or not.
Examples
The following example enables the transmission of RIP packets:
Switch(config-if)# ip rip send-packet