CANOGA PERKINS CanogaOS Command Reference - Manual (Page 128)

CanogaOS Command Line Reference
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 128 of 855
When the mode is changed, both the mac learned dynamically and configured statically on the port will
be cleared.
Examples
This example shows how to set the switchport mode to trunk.
Switch(config-if)# switchport mode trunk
Related Commands
switchport mode access
6.19 switchport mode trunk ingress-filter
Use this command to set ingress-filter configuration of the trunk port .
Command Syntax
switchport mode trunk ingress-filter {enable |disable}
enable: enable the ingress-filter
disable: disable the ingress-filter
Command Mode
Interface configuration
Defaults
enable
Usage
The trunk port ingress-filter configuration should only be allowed on a trunk port.
When the ingress-filter is disabled, this port will not check the vlan ID of received ingress packets.
Examples
This example shows how to set the trunk port ingress-filter to disable.
Switch(config-if)# switchport mode trunk ingress-filter disable
Related Commands
switchport mode trunk
6.20 switchport trunk allowed
Use this command to allow traffic from specified vlan to transmit the trunk port.
To remove this setting, use the no form of this command.