CANOGA PERKINS CanogaOS Command Reference - Manual (Page 378)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 378 of 855
19.9.1.2 Syntax Description
LOCAL-PREFERENCE <0-4294967295> Species the preference value.
19.9.1.3 Command Mode
Route-map mode
19.9.1.4 Defaults
No match local-preference is specified by default.
19.9.1.5 Examples
Switch# configure terminal
Switch(config)# route-map mymap permit 3
Switch(config-route-map)# match local-preference 100
19.9.1.6 Related Commands
match community
match as-path
set as-path
set community
match ip next-hop
19.10 match metric
Use this command to match a metric of a route.
Use the no parameter with this command to disable this function.
The match metric command specifies the metric to be matched. If there is a match for the
specified metric, and permit is specified, the route is redistributed or controlled as specified by
the set action. If the match criteria are met, and deny is specified, the route is not redistributed
or controlled. If the match criteria are not met, the route is neither accepted nor forwarded,
irrespective of permit or deny specifications.
The route specified by the policies might not be the same as specified by the routing protocols.
Setting policies enable packets to take different routes depending on their length or content.
Packet forwarding based on configured policies overrides packet forwarding specified in routing
tables.
Note:
This command is valid for BGP, OSPF and RIP only.