CANOGA PERKINS CanogaOS Command Reference - Manual (Page 582)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 582 of 855
28.26.1.4 Defaults
No set originator-id is specified by default.
28.26.1.5 Examples
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3
Switch(config-route-map)# set originator-id 1.1.1.1
28.26.1.6 Related Commands
28.27 set tag
Use this command to set a specified tag value.
Use the no parameter with this command to return to the default.
Tag in this command is the route tag which is labeled by another routing protocol (BGP or other
IGP when redistributing), because AS-external-LSA has a route-tag field in its LSAs. Also, with
using route-map, ZebOS can tag the LSAs with the appropriate tag value. Sometimes, the tag
matches with using route-map, and sometimes, the value
may be used by another application.
Note:
This command is valid for OSPF and RIP only.
28.27.1.1 Command Syntax
set tag TAGVALUE
no set tag
28.27.1.2 Syntax Description
TAGVALUE <0-4294967295> Tag value for destination routing protocol.
28.27.1.3 Command Mode
Route-map mode