CANOGA PERKINS CanogaOS Command Reference - Manual (Page 236)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 236 of 855
Command Syntax
router rip
no router rip
Default
No RIP routing process is defined.
Command Mode
Global configuration
Usage
Examples
The following example shows how to begin the RIP routing process:
Switch(config)# router rip
Related Commands
network (RIP)
14.17 timers basic (RIP)
To adjust Routing Information Protocol (RIP) network timers, use the timers basic command in router
configuration mode. To restore the default timers, use the no form of this command.
Command Syntax
timers basic update timeout invalid
no timers basic
update Rate (in seconds) at which updates are sent. This is the fundamental timing
parameter of the routing protocol. The default is 30 seconds.
timeout Time (in seconds) after which a route is declared invalid without updates that
refresh the route. The route then enters into an invalid state and is not used for
forwarding packets. It is marked inaccessible and advertised as unreachable.
The default is 180 seconds.
invalid Time after which an invalid route is removed from RIP routing database. The
default is 120 seconds.
Default
No RIP network timers are adjusted.
Command Mode